Hi George,

Sounds a bit strange, but I'm not 100% sure what the exact problem was (apart from user error).  I suspect a major part of the problem was not giving the course completion enough time to update.  I was expecting course completion to occur immediately once the learner achieved the course completion criteria, and when it didn’t update immediately I naturally assumed the settings were wrong, so of course I continued to change the settings.

Once I realised the above, I started a new test course with test learners from scratch and made sure the following settings were correct:

1. Activity Completion settings – student must receive a grade to complete this activity
2. Course Completion settings – “Any of the selected activities to be complete” and “Required course grade 100.0”
3. In the Grader Report – I set the Category Grade Maximum (100.0) and Pass Grade (100.0).  In each activity, I set the Grade to Pass

See attached for end result.

Thanks again

Michelle